Emergency
Sewage Backup Cleanup in Erie, CO
Porous material that has touched it is not dried, it is removed. That single rule is what makes this the dearest water loss at any volume. Category is a pricing rule before it is anything else. Porous material that has been in contact with sewage is removed and replaced rather than dried and returned, which converts what would have been equipment days into demolition, disposal and rebuild across the affected area - the same volume of water, a far larger scope.
The pro who inspects is the pro who quotes
Every pro in our network is licensed and insured in Colorado.
Often needed alongside
- Emergency Water Extraction
The cheapest stage of a water loss, and the one that decides how expensive the rest of it gets. Standing water is removed before it moves into the structure.
- Groundwater & Basement Water Intrusion
The lowest point in the house is usually the most finished. That combination is what makes below-grade water the most expensive square footage on the estimate.
- Structural Drying & Dehumidification
Units times days, ending on a measured reading. The most checkable line on a water estimate, and the alternative to cutting material out.
Frequently asked questions
The basement was unfinished. Is that a cheap loss?
The structure is, and the contents may not be. A bare slab and framed walls dry quickly with few machines, so mitigation is modest. What sits on the floor is a separate matter, handled by a different process and often under a different part of a policy, so ask for contents as its own figure from the start.
How are stored contents handled?
Usually inventoried, then sorted into cleanable, restorable and lost. That work is priced by item or by the hour rather than by area, so it does not appear on the structural estimate at all. Getting the inventory started early matters more than it sounds, because the sort is easier before anything sits wet.
Why is framing still being dried when the slab reads dry?
Because bottom plates sit on the slab and wick from it. Timber in contact with a wet floor holds moisture after the surface has gone, and drywall added later over a wet plate creates a problem that is invisible until it is expensive. Ask for the plate readings specifically rather than the room average.
This FAQ belongs to the Erie page; it is repeated here.